GO Networks WLP Technical Manual page 23

WDS root configuration is controlled by:
configure wds root [ true | false ]
To display the current WDS configuration use:
show wds params
WDS is always used on the BH radio while the access radio can be
configured to use as Access-only, pure backhauled, or mixed operation by
the following command:
configure interface dot11Radio 0 service [access | backhaul |
both]
To activate the automatic topology detection mode (meshing mode) the
user has to enable this mode at both devices he wishes to connect and
configure them to the same radio channel. Automatic WDS topology
detection is currently supported on the BH radio or the access radio. Trying
to configure both radios to automatic mode will result in an error message.
To enable automatic mode use:
configure interface [dot11radio | BHRadio ] 0 wds-auto-
discovery enable
Once automatic mode has been enabled, the route candidates can be
viewed using:
show WDS candidates
The current parent, active children, and static-defined peers can be viewed
using:
show WDS nodes
- Page 21 of 31-
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.