Configuring The Wlp; Connect And Access The Wlp - GO Networks WLP Technical Manual

Following is a brief overview of the main CLI commands that are used to
configure the WLP. A configuration example follows the detailed list of
configuration commands. These and other CLI commands are detailed in
the GO MBW CLI Reference Guide.

Connect and Access the WLP

Initial configuration of the WLP is done using a serial cable. A standard
RS232-interface DB-9 cable is connected to the COM port of a laptop or a
PC to the WLP unit's console port. For more information regarding the
serial cable, see Appendix B, Wiring Specifications.
Once the WLP IP address is configured, the rest of the configuration can be
done using Telnet via the network.
Notebook PC
Consol Port: Consol Port:
RS232 RS232
Figure 7: Connect and Access the WLP
All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.

Configuring the WLP

Consol Port: Consol Port:
RS232 RS232
- Page 15 of 31-
WLP