Configuring The Management Connectivity; Configuring The Radio Settings; Setting The Radio Data Rates - GO Networks WLP Technical Manual

in turn, determines whether you can view configuration and operation
parameters, or implement changes. A new user and password name
should be added; however this default name and password can be used for
the initial configuration.
The default system name for the unit is set to WLS.

Configuring the Management Connectivity

Configuring the management connectivity involves setting the Fast
Ethernet connection as well as defining the default gateway. These
procedures are detailed in the following section.
Define the static IP address and the subnet mask on the same network
through which you connect to the WLP. You can use the CLI command:
configure ip address <ip address>, as shown below:
configure ip address 192.168.30.102 255.255.255.0
The default is IP is fixed on 192.168.0.10
Note: If you are using DHCP client on the first gateway, you do not
need to configure the default gateway.
Default Gateway
Define the default gateway by using the Configure mode (consult with your
network administrator). You can use the CLI command:
configure ip default-gateway <ip address> disable/enable, as
shown below:
configure ip default-gateway 192.168.30.254
Note: If you are using DHCP client on the first gateway, you do not
need to configure the default gateway.

Configuring the Radio Settings

By default, the channel is configured to channels 1 (2.412 GHz). You can
define different configurations for each channel by using the following CLI
command:
configure interface dot11Radio 0 channel 6

Setting the Radio Data Rates

All contents are Copyright © 2006 GO Networks, Inc. All rights reserved.
- Page 17 of 31-