Starting The Engine; Stopping The Rider; Pushing The Rider By Hand - Snapper S200KAV2561, S200XK2761 Operator's Manual

Starting the Engine

WARNING
If you do not understand how a specific control
functions, or have not yet thoroughly read the
FEATURES & CONTROLS section, do so now.
Do NOT attempt to operate the tractor without first
becoming familiar with the location and function of ALL
controls.
1. While sitting in the operator's seat, engage the parking
brake by pulling the parking brake lever back, make sure
the PTO switch is disengaged (pressed down fully) and
the motion control handles are locked in the NEUTRAL
position.
2. NOTE: A warm engine may not require choking.
Set the engine throttle control to FULL throttle position.
Then fully close the choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to
START.
4. After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and
allow to warm up.
Warm up the engine by running it for at least a minute
before engaging the PTO switch or driving the rider.
5. After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be stopped
by simply turning the ignition switch to STOP. Use this
method only in emergency situations. For normal engine
shut down follow the procedure given in STOPPING THE
RIDER.

Stopping the Rider

1. Returning the ground speed control levers to the middle
position will stop rider movement. Pivot the levers
outward and lock them in NEUTRAL.
2. Disengage the PTO by pushing down on the PTO switch.
3. Engage the parking brake by pulling the handle up until
it locks into position.
4. Move the throttle control to mid-throttle position and
turn the ignition key to OFF. Remove the key.

Pushing the Rider By Hand

NOTICE
DO NOT TOW RIDER
Towing the units will cause hydraulic pump and wheel
motor damage. Do not use another vehicle to push or
pull this unit.
1. Disengage the PTO, engage the parking brake, turn the
ignition OFF, and remove the key.
2. Lift the seat plate to gain access to the hydraulic pumps.
3. To disengage the pumps (free-wheel position), turn the
hydraulic release valves (A, Figure 8) located on the
pumps COUNTER-CLOCKWISE a maximum of 2 full
turns.
4. Disengage the parking brake.
The tractor can now be pushed by hand.
5. After moving the tractor, re-engage the pumps (drive
position) by turning the release valves CLOCKWISE and
tighten to 80-120 in. lbs. of torque.
A
Figure 8. Hydraulic System By-Pass
A. Hydraulic Release Valve
(left-hand pump shown)
Operation
19