Hydraulic Pump Drive Belt Replacement - Snapper S200KAV2561, S200XK2761 Operator's Manual

Regular Maintenance

Hydraulic Pump Drive Belt Replacement

1. Park the tractor on a smooth, level surface such as a
concrete floor. Disengage the PTO, engage the parking
brake, turn off the engine, and remove the ignition key.
2. Remove the PTO drive belt (see MOWER BELT
REPLACEMENT for removal instructions).
3. Remove the hardware that secures the clutch anchor
pad to the PTO clutch.
WARNING
STORED ENERGY DEVICE: Improper release of the belt
tension spring can result in personal injury.
Use extreme caution when removing this spring.
4. Loosen the nut on the spring anchor eyebolt (G, Figure
43) to release the majority of the belt tension. Use
caution and remove the nut to completely release the
tension.
5. Remove the old belt and replace it with the new one.
Make sure the V-side of the belt runs in the grooves of
the crankshaft pulley and pump pulleys (B & C).
6. Reinstall the spring anchor eyebolt (G) into the anchor
tab and loosely fasten the nut. Adjust the anchor
eyebolt until a measurement of 8-3/8" (21,2 cm) is
achieved from the outside if the spring hooks. Tighten
nut.
7. Reinstall the clutch anchor pad to the PTO clutch and
secure with the hardware previously removed.
8. Reinstall the PTO drive belt.
36
B
G
D
F
E
A
C
Figure 43. Hydraulic Pump Drive Belt Replacement
A. Pump Drive Belt
B. Crankshaft Pulley
C. Pump Pulley
D. Idler Pulley
E. Idler Arm
F. Spring
G. Spring Anchor Eyebolt
8 3/8"
(21,2 cm)
C
www.SnapperPro.com