Wiring Connections - red lion MODULAR CONTROLLER SERIES Manual

WIRING

WIRING CONNECTIONS

All conductors should meet
voltage and current ratings for
each terminal. Also, cabling
should conform to appropriate
standards of good installation,
local codes and regulations.
When wiring the module, use
the numbers on the label to
identify the position number
with the proper function. Strip
the wire, leaving approximately
1/4" (6 mm) of bare wire
exposed. Insert the wire into
the terminal, and tighten.
CSPID1 INPUT CONNECTIONS
INPUT COM.
SENSE
TC/RTD+
SENSE
EXC./
RTD +EXE
JUMPER
N/C
0-10 V
4-20 mA
RTD
INPUT COM.
TC/RTD+
+
RTD +EXE
N/C
0-10 V
4-20 mA
Thermocouple and Millivolt
CSPID2 INPUT CONNECTIONS
INPUT COM.
SENSE
TC/RTD+
SENSE
EXC./JUMPER PROC/RTD EXC
INPUT COM.
SENSE
TC/RTD+
SENSE
EXC./JUMPER PROC/RTD EXC
RTD
INPUT COM.
TC/RTD+
+
PROC/RTD EXC
INPUT COM.
TC/RTD+
+
PROC/RTD EXC
Thermocouple and Millivolt
Terminals 13 to 18
13
Terminals 7 to 12
7
Terminals 1 to 6
1
VDC-
VDC+
Voltage
mA DC-
mA DC+
Current
VDC-
VDC+
VDC-
VDC+
Voltage
mA DC-
mA DC+
mA DC-
mA DC+
Current
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT
WHILE CIRCUIT IS ALIVE UNLESS AREA IS KNOW TO BE
NON-HAZARDOUS.
INPUT AND OUTPUT (I/O) WIRING MUST BE IN
ACCORDANCE WITH CLASS I, DIV. 2 WIRING METHODS
AND IN ACCORDANCE WITH THE AUTHORITY HAVING
JURISDICTION.
INPUT COM.
TC/RTD+
RTD +EXE
N/C
0-10 V
4-20 mA
INPUT COM.
TC/RTD+
RTD +EXE
N/C
0-10 V
4-20 mA
INPUT COM.
TC/RTD+
PROC/RTD EXC
INPUT COM.
TC/RTD+
PROC/RTD EXC
INPUT COM.
TC/RTD+
PROC/RTD EXC
INPUT COM.
TC/RTD+
PROC/RTD EXC
5
OP1 +
Heater Circuit
OP1 COM
OP2 +
OP2 COM
HCM (OPT)
HCM (OPT)
AC
Heater Current Monitor
Heater Circuit
OP4 +
OP4 COM
HCM
HCM
{
HCM
SAME AS
HCM 1
HCM
AC
Heater Current Monitor