Download Print this page
red lion CR3000 Manual

red lion CR3000 Manual

Cr3000 module, hspa+ cellular module
Hide thumbs Also See for CR3000:

Advertisement

Quick Links

Inside US: +1 (877) 432-9908
 
Outside US: +1 (717) 767-6511
www.redlion.net
CRM000 CM CMOD0 000 ‐ CR3000® HSPA+ Cellular Module
FOR USE IN HAZARDOUS LOCATIONS:
Class I, Division 2, Groups A, B, C, and D
T4
IND.CONT. EQ.
E317425
GENERAL DESCRIPTION 
The CRM000 CM CMOD0 000 is a cellular communication module
designed for use with the CR3000 products. The module provides the
CR3000 host device cellular data connectivity. The cellular standard
adopted in this module is HSPA+ with fallback capability to 3G and 2G. It
can get speeds up to 21 Mbps downlink and 5.76 Mbps uplink. It's built
upon the GSM standard, offered in the US through AT&T and T-Mobile
and widely available throughout the world. HSPA+ can be used for
services such as Wireless Application Protocol (WAP) access, Short
Message Service (SMS), and for Internet connectivity.
The HSPA module is penta-band, allowing it to work in frequencies
across the Americas, Europe and Asia. US and Canada work in the 850/
1900 MHz bands, while Europe, Middle East, Africa and most of Asia
work in the 900/1700/2100 MHz HSPA+ frequencies.
The HSPA module requires the addition of a SIM (Subscriber Identity
Module) card, which is inserted into the holder prior to installation of the
HSPA module. The SIM card securely stores the service-subscriber key
(IMSI) used to identify a subscriber, and is used to connect to the
network to obtain an IP address from the cellular provider.
The modules connect and communicate via proprietary USB
connection to the various CR3000 devices. The CR3000 devices,
equipped with serial ports as well as Ethernet port(s), allow the system to
share data with PCs, PLCs and SCADA systems.
DIMENSIONS In inches (mm)
1.26 (32)
CONFIGURATION
3.1 software. The software is an easy to use, graphical interface which
provides a means of configuration and commissioning of new systems,
as well as routine module re-calibration.
SAFETY SUMMARY
in this literature or on equipment must be observed to ensure personal
safety and to prevent damage to either the instrument or equipment
connected to it. If equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
actuators not equipped with safeguards. To do so can be potentially
harmful to persons or equipment in the event of a fault to the unit.
separation distance of at least 7.87 inches (20 cm) from all persons.
3.58 (90.8)
4.60
(116.8)
-1-
CONFIGURED USING CRIMSON SOFTWARE (VERSION 3.1 OR
LATER)
SUPPORTS HSPA+ CELLULAR DATA CONNECTIVITY WITH FALL
BACK TO 3G AND 2G
UP TO 21 MBPS DOWNLINK/5.76 MBPS UPLINK SPEEDS
POWERED AND CONFIGURED FROM CR3000 HOST DEVICE
The CR3000 host is configured with Windows
All safety related regulations, local codes and instructions that appear
Do not use this unit to directly command motors, valves, or other
The antenna used for this module must be installed to provide a
WARNING - EXPLOSION HAZARD - DO NOT D
CAUTION: Risk of Danger.
Read complete instructions prior to installation
EQUIPMENT UNLESS POWER HAS BEEN SW
and operation of the unit.
OR AREA IS KNOWN TO BE NON-HAZARDOU
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT
EQUIPMENT UNLESS POWER HAS BEEN SWITCHED OFF
EQUIPMENT UNLESS POWER HAS BEEN SWITCHED OFF
OR AREA IS KNOWN TO BE NON-HAZARDOUS.
OR AREA IS KNOWN TO BE NON-HAZARDOUS.
Bulletin No. CRMCMOD-A
Drawing No. LP1052
Effective 2018-05-17
®
®
compatible Crimson

Advertisement

loading
Need help?

Need help?

Do you have a question about the CR3000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for red lion CR3000

  • Page 1 The CR3000 host is configured with Windows compatible Crimson designed for use with the CR3000 products. The module provides the 3.1 software. The software is an easy to use, graphical interface which CR3000 host device cellular data connectivity. The cellular standard provides a means of configuration and commissioning of new systems, adopted in this module is HSPA+ with fallback capability to 3G and 2G.
  • Page 2: Specifications

    Drawing No. LP1052 SPECIFICATIONS 6. ANTENNA CONNECTOR: SMA Female connector requires: 1. POWER: Power will be supplied by the CR3000 host device. 50 Ohm antenna with SMA male connector HSPA Max Power: Penta-band HSPA+ antenna (850/900/1700/1900/2100 MHz) for HSPA+ Mode: During continuous active webserver traffic global support.
  • Page 3 HARDWARE INSTALLATION SIM CARD INSTALLATION HSPA MODULE INSTALLATION Before installing the module in the CR3000 host device, a SIM Card Remove polycarbonate module plug and attach module to CR3000. from one of the GSM/HSPA+ providers, with data enabled, has to be Torque screws to 6.0 pound-force inch [96 ounce-force inch] (0.68 Nm).
  • Page 4 A listing of the entire CR3000 family of products and accessories can be found at www.redlion.net. LIMITED WARRANTY (a) Red Lion Controls Inc. (the “Company”) warrants that all Products shall be free from defects in material and workmanship under normal use for the period of time provided in “Statement of Warranty Periods” (available at www.redlion.net) current at the time of shipment of the Products (the “Warranty Period”).