Print Head Container - Olivetti JP 883 User Manual

This operation MUST NOT be repeated
systematically, as it will damage the print head.
It should ONLY be attempted as a last resort,
before changing the ENTIRE print head.
1. Dampen a tissue handkerchief with distilled
water; squeeze it slightly to remove any
excess water.
2. Open the printer cover.
3. Position, release and remove the print head.
4. Holding the print head with the nozzles facing
downwards, blot it against the handkerchief,
pressing lightly.
5. Repeat the blotting operation a few times on
different areas of the handkerchief, to clean
the nozzles.
6. Reinsert the print head in the printer and close
the printer cover.
7. Print the "demo" page to check the quality of
printing (see the specific paragraph in
"Preparing the printer using the printer
monitor ").
More about print heads

Print head container

Instead of the standard colour print head, you can
use an optional economy colour printer head with
replaceable cartridge, available from your dealer.
This optional print head has the same function
and duration as the standard colour print head,
but has a slightly inferior output. If you do not
intend to print photographs or high quality colour
ouput, you may find this optional print head more
economic to use.
If you decide to buy and use the optional colour
print head, you MUST also acquire and use a
print head container (see "Supplies and options")
to store the standard colour print head that you
have removed from the printer.
standard colour print head, IMMEDIATELY, AS
IT IS, in the storage container, closing the lid
securely to prevent the ink drying and blocking
the print nozzles.
DO NOT PLACE TAPE, PAPER, OR ANY
OTHER MATERIAL OF THE PRINT HEAD
NOZZLES.
You can then insert the optional colour print head
in the printer, following the print head insertion
procedure described in the Installation Guide.
Place the
19