Parts Supplied; Required Additional Components - Raymarine SPX 10 Installation Instructions Manual

2.6 Parts supplied

1
SMART
10x
5x
2x
4x
5 6
8 9
3x
2x
11 12
2x
1. SPX course computer
2. 1 m (3.3 ft) SPX - SeaTalk ng spur cable
3. 400 mm (15 in) SeaTalk ng backbone cable
4. SeaTalk ng T-piece
5. Fluxgate compass
6. Course computer mounting screws and cable ties
7. Documentation pack
8. Rudder reference (Not supplied with SPX-10)
9. Ball joint cap (Not supplied with SPX-10)
10. Ball joint (Not supplied with SPX-10)
11. Rudder reference mounting screws (Not supplied
with SPX-10)
12. M6 threaded bar (Not supplied with SPX-10)
Planning the installation
2.7 Required additional
components
2
To complete your autopilot system, you will need the
following components in addition to the SPX core pack.
3
• Compatible autopilot controller.
• Drive unit appropriate for your boat and autopilot
course computer.
• Power and drive cables.
4
Autopilot controllers
There are a number of autopilot controllers available for
connection to your system.
The autopilot controller may be connected using
7
either SeaTalk
course computer and any existing marine electronics
10
connected.
D11934-1
1
4
7
ng or SeaTalk, depending upon the
2
MODE
ST ANDBY PIL OT
5 6
S100 REMOTE
8
9
Pilot controller
1 ST70+
2 ST8002
3 ST6002
4 ST70
5
ST7002
6 Smart controller
7
p70R
8 p70
9
S100 remote
Drive units
3
The drive unit interfaces with the boat's steering system.
The type of drive required depends upon your boat and
associated steering system.
SeaTalk ng SeaTalk
●
● (repeat
controller
only)
●
●
●
● (repeat
controller
only)
●
● (repeat
controller
only)
● ●
● ●
● (repeat
controller
only)
D10451-2
15