Advertisement
Installation
Assemble the swivel wheel kit according to the follow-
ing steps.
1 . Put front of cart on cement block or other type of
support in place of removed caster wheel.
2 . Fig. 2. Drill two holes thru right side of chassis
frame as viewed from front.
4X
.330
Thru. Both Walls
1.0 in
Fig. 2
3 . Fig. 3. Mount cable bracket (11) on right side of
cart (110), as viewed from front, with two flange
screws (15) and two lock nuts (16).
4 . Slide actuator lever (9) on cart handle (H) and
tighten. Install handle grip (18). Replace other
handle grip if needed.
5 . Insert two cap screws (13) into front caster
bracket (12) and mount on front of cart (110).
6 . Assemble swivel caster (1) to cart (110) and cap
screws (13) extending thru cart. Fasten with two
lock nuts (14) and washers (19) and tighten.
7 . Install one end of cable (10) in actuator lever (9).
8 . Route cable (10) from actuator lever (9) down
handle and between cart base (110) and motor
mount plate (108) to swivel caster (1). Fasten
cable to cable bracket using nut provided with
cable.
9 . Install compression spring (8) over cable wire and
in front of caster wheel (1).
2
308943
1.0 in
Front
5.55 in
8851A
10 . Fig. 4. Install wire stop (7) on cable wire (10) and
finger tighten wire stop screw.
9
18
H
16
110 Ref
14
19
Fig. 3
Cable Adjustment
Adjust the cable as follows:
1 . Fig. 4. Make sure cable is routed between the top
of sprayer frame and underneath the motor mount
plate.
2 . Check that cable is snug and cable nut (A) under
spring is tight. Extend cable wire and draw tight in
wire stop (7). Tighten wire stop screw.
3 . Check that release lever frees wheel to turn.
Readjust cable if necessary.
7
A
Fig. 4
10
11
15
8
1
7
12
13
8835A
Advertisement
