Installation - Lindy 32937 Manual

Short Installation Manual
• Switch off all devices to be connected.
• Connect the CPU Switch LITE Audio to the computers
and to your keyboard, monitor, mouse and audio devices
using the appropriate KVM+Audio cables.
• Switch on the monitor followed by the computers.
• Don't switch the channels during boot up of the
connected computers. For operation you can change the
computer ports either by pressing the red push button or
by hotkey from your keyboard: press the SCROLL LOCK
key twice within less than 2 seconds and then use cursor
up or down or port number key.
Detailed information can be found under the
Installation and Operation Sections of this manual.
English Manual
Overview
Comparison to CPU Switch LITE 2/4 Port Models 32925, 32927:
Besides the additional AUDIO support LINDY CPU Switch LITE AUDIO also offers extended
mouse compatibility. It supports the most widely used 4D/5D mice with one or two scroll
wheels and up to 5 buttons. It also supports most RF mice and their battery status report
function.
The LINDY CPU Switch LITE AUDIO allows you to access up to four PCs using one keyboard,
monitor and mouse. The keyboard and mouse connectors on the PCs both have to be PS/2
style. By using this switch you can save on the additional cost of keyboards, monitors and mice.
You will also save on desk space and eliminate the problems of using the wrong keyboard or
mouse and all the trouble associated with this.
This unit is a pure hardware solution and will therefore work with all operating systems. This unit
does not require any software installation. You simply connect the cables between the KVM
Switch LITE AUDIO and your computers, and then turn on the computers.
The CPU Switch LITE AUDIO supports two methods of switching between the connected
computers: by pressing the red push button or via keyboard hotkeys.
The CPU Switch LITE AUDIO emulates the keyboard and mouse connections for all connected
PCs permanently. This prevents error messages when switching between connected PCs.
FEATURES
• Supports monitor resolution up to 2048 x 1536, Bandwidth 400MHz
• Permanent keyboard and mouse emulation
• Supports PCs with PS/2 type connectors
• Supports extended PS/2 bus protocols
• Supports Hot Pluggable
• Supports audio devices with 3.5mm Stereo connectors (Speaker/Line Out & Microphone/Line In)
• Serial Mice and connectors are NOT supported
• Connection with KVM+Audio LINDY cables for SVGA, Audio and PS/2
• No power supply required.

INSTALLATION

Before you start please switch off all the computers to be attached.
Please note that LINDY CPU Switch LITE AUDIO uses special KVM+Audio cables to attach to
each computer. At the CPU Switch side the audio signals are routed through the PS/2
connectors. At the other of the cable the microphone and speaker signals are separated. You
can use standard 3in1 KVM cables or standard cables if you don't require the audio function.
Apart from the PCs connected you will only need one keyboard, monitor, PS/2 mouse, optional
speakers and microphone, and the KVM+Audio cables to connect the ports of your PCs to the
LINDY CPU Switch LITE AUDIO. If some cables are not long enough we recommend that the
complete cable be replaced with a longer length rather than using extension cables.
1