Importing Programs And Banks; Calibrating The Prophet Rev2; Calibrating The Oscillators And Filters; Calibrating The Pitch And Mod Wheels - Sequential Prophet Rev 2 User Manual

Programs can also be dumped directly from one Rev2 to another using
the MIDI DIN jack, if the
midi sysex cable
menu.
global
To export a program or bank as a SysEx file over MIDI:
1. Connect two Rev2 synthesizers together using MIDI cables and the
jacks on their rear panels.
midi in and midi out
2. Press the button on Rev2 that you want to send programs from.
global
3. On both synthesizers, use the
, then use the knob to choose
cable value
4. On the Rev2 that you want to send the programs from, press the
button (if it's not already on) and use the
, , or
dump prog dump bank dump all banks
these you would like to do.
5. Press . The program or bank is exported to the other Rev2.
write

Importing Programs and Banks

You can use a MIDI librarian application such as such as SysEx Librar-
ian for Macintosh, or MIDIOX for Windows to transmit exported
program or banks back into your Prophet Rev2. You will need a
computer and an appropriate software application.
The Prophet Rev2 is compatible with Prophet '08 sounds, so you can
import any Prophet '08' programs and they will sound just as good, if not
better!
To import a program or bank as a SysEx file over MIDI:
1. Connect your synthesizer to a computer using a USB cable (or MIDI
cable, if you are using a dedicated MIDI interface).
2. Press the button on your Rev2.
global
3. Use the knob to select
parameter
knob to choose either or
usb
using to connect to your computer.
4. Open your MIDI librarian software and configure it to send SysEx
messages to your synthesizer.
68 Importing Programs and Banks
parameter is set to in the
midi
knob to select
parameter midi sysex
.
midi
global
knob to select
parameter
, depending on which of
, then use the
midi sysex cable value
, depending on which port you are
midi
Sequential
5. In the MIDI librarian, open the programs and/or banks you want to send.
6. Transmit the programs. The Prophet Rev2 should load them. They will
replace any existing programs in those memory locations on the synth.
Programs will load back into the same bank and program locations from which
they were originally exported.

Calibrating the Prophet Rev2

Because the Prophet Rev2 is calibrated at the factory, controls such as
the Pitch and Mod wheels shouldn't require re-calibration. However, if
for some reason you experience unexpected behavior with these controls,
you can use the built-in calibration function to tune them occasionally.

Calibrating the Oscillators and Filters

To calibrate the oscillators and filters:
1. Press the button.
global
2. Use the knob to select
parameter
3. The synthesizer performs its auto-calibration procedure. Don't turn off
the power while it's doing this.
4. When finished, the front panel controls will return to normal and you
can play the Prophet Rev2 again.

Calibrating the Pitch and Mod Wheels

To calibrate the Pitch and Mod wheels:
1. Press the button.
global
2. Use the knob to select
parameter
instructions in the display.
3. When finished, the front panel controls will return to normal and you
can play the Prophet Rev2 again.
Prophet Rev2 User's Guide
, then press the button.
calibrate write
, then follow the
calibrate wheels
Calibrating the Prophet Rev2 69