5.1
Overview
Transmitter display modes
The transmitter has the following display modes.
•
Test. Appears briefly after power-up to self-test the display.
•
Connection status. Appears when transmitter is not fully connected to the OneWireless network. See
section 5.2.
•
PV display. Default mode of the transmitter displays the PV and any status messages. See section 5.3
on page 23.
•
Quick view of transmitter identification parameters. Displays read-only parameters then returns to PV
display. See section 5.4 on page 27.
•
Menu. See section 5.5 on page 28.
Authentication Device
To navigate the transmitter displays and menus, hold the Authentication Device no more than 6" (15 cm)
from the transmitter and aim the infrared beam at the transmitter display while tapping the Device Local
Configuration buttons (Table 10). You can also use the PDA's buttons.
Authentication Device menus are described in section 5.6 starting on page 29.
Rev. 3
OneWireless XYR 6000 Temperature and Temperature/Discrete Input Transmitter User's Manual
6/24/08
5. Operation
5. Operation
5.1. Overview
21