How To Program; Programming Your Lock - Emtek EMTouch Installation & Programming Manual

How to Program

Programming Your Lock

In order to perform each of the following six functions, the lock must first be
placed in Programming Mode:
1. Press and hold EMTEK button for 3 seconds
2. Yellow LED flashes, then remains solid*, number keys also illuminate
3. Enter Programming Code
4. Yellow LED flashes, then 2 beeps
5. Yellow LED remains solid (awaiting button press; see following Table)
I
f you wIsh to
Change
Programming
Code
(6 digits)
Add User Code
(4 digits)
(Store up to 20
User Codes)
Delete User Code
**
Enable/Disable
All User Codes
Delete All User
Codes
Turn Beeper On/
Off
*If no input within 20 seconds, Yellow LED goes out, Red LED flashes and lock exits Programming Mode.
**Also referred to as "vacation mode". This command temporarily disables all user codes (metal key
override will still work).
10
P A
ress
B
utton
1
Enter New
Programming
Code
(6 digits)
2
Enter New
User Code
(4 digits)
3
Enter User
Code to be
Deleted
4
Entering '4' disables all Users
(enables all if disabled)
5
Re-Enter Programming Code
6
Entering '6' turns OFF (or ON)
ctIons
• 1 Green LED flash
Re-Enter
New
• 1 beep
Programming
• 1 Green LED flash
Code
• 1 beep
• 2 Green LED flashes
(6 digits)
• 2 beeps
• 1 Green LED flash
Re-Enter
New User
• 1 beep
Code
• 1 Green LED flash
• 1 beep
(4 digits)
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
Re-Enter
User Code to
• 1 beep
be Deleted
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
• 1 Green LED flash
• 1 beep
• 2 Green LED flashes
• 2 beeps
I
ndIcAtors