Security Setting; Power Setting - J&W nVIDIA MCP78 Series User Manual

nVIDIA MCP78 Series

4.5.6 Security Setting

Main Advanced
Security Settings
Supervisor Password : Not Installed
User Password
Change Supervisor Password
User Access Level
Change User Password
Clear User Password
Password Check
Boot Sector Virus Protection
Flash Write Protection
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
This item allows you to
characters, and press <Enter>. The password typed now will clear any previously entered
password from CMOS memory. You will be asked toconfirm the password. Type the password
again and press <Enter>.
Note: Don't forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
Flash Write Protection
•
The item is used to enable or disable the BIOS Flash Write Control for non-Award flash utility.
Select [Enabled] when performing BIOS update with the non-Award flash utility. Ignore this
option if you use the Award flash utility. Default value is [Disabled].

4.5.7 Power Setting

Main Advanced
Power Settings
► ACPI Configuration
► APM Configuration
► PC Health
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
BIOS SETUP UTILITY
Boot Security
: Not Installed
[Full Access]
[Setup]
[Disabled]
[Enabled]
Chage Supervisor/User Password, Type the password, up to eight
BIOS SETUP UTILITY
Boot Security
- 2 -
Power JUSTw00T!
Install or Change the
password.
←
Select Screen
Select Item
↑ ↓
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
Power JUSTw00T! Exit
Section for Advanced
ACPI Configuration.
←
Select Screen
Select Item
↑ ↓
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
User's Manual
Exit