Dynamic Routing Using Routing Information Protocol (Rip); Dynamic Routing (Rip); Configuration Parameters; Table 7.1 Dynamic Routing (Rip) Configuration Parameters - Asus SL1200 User Manual

7.2 Dynamic Routing using Routing Information
Protocol (RIP)
RIP enables routing information exchange between routers; thus, routes
are updated automatically without human intervention. Please note that
RIP service must be enabled first in the System Management / System
Services configuration page if you want to use RIP to exchange routing
information with other routers.
7.2.1 Dynamic Routing (RIP) Configuration Parameters
Table 7.1 defines the available configuration parameters for dynamic
routing.
Table 7.1. Dynamic Routing (RIP) Configuration Parameters
Field
Interface
RIP
Passive Mode
RIP Version (Send)
RIP Version (Receive)
Chapter 7 - Configuring Routes
Description
Select the interface through which the routing information
exchange is desired. You may configure all or some
interfaces to support routing information exchange.
Click the Enable or Disable radio button to enable or disable
RIP for the interface selected. You must enable RIP service
first in the System Management -> System Services
configuration page if you want to enable RIP to exchange
routing information. The default setting is Enable.
Enable this mode if RIP configured for this interface will only
receive routing information from other routers and not send
routing information to other routers. Disable this mode if you
want this interface to send and receive routing information
to/from other routers. The default setting is Enable.
Select the RIP version for sending the routing information.
Three options are available: Version 1, Version 2, and
Both. The default setting is Version 2.
Select the RIP version for receiving the routing information.
Three options are available: Version 1, Version 2, and
Both. The default setting is Both.
ASUS SL1200
49