Garmin G1000 Cockpit Reference Manual page 140

Appendix
NOTE: After the navigation database is loaded or copied, the top SD card
may be removed.
1) With the system OFF, insert the SD card containing the new navigation database
version into the top card slot of the display (PFD1, PFD2 or MFD) to be updated
(label of SD card facing left).
2) Turn the system ON. A prompt is displayed in the upper left corner of the
display:
3) Press the NO Softkey to proceed to loading the active database.
4) A prompt similar to the following is displayed. Press the YES Softkey to update
the active navigation database.
5) After the update completes, the display starts in normal mode.
6) Turn the system OFF and remove the SD card from the top card slot.
7) Repeat steps 1 through 6 for the other displays (PFD1, PFD2, or MFD).
8) Apply power to the system and press the ENT Key to acknowledge the startup
screen.
9) Turn the large FMS Knob to select the AUX Page group on the MFD.
10) Turn the small FMS Knob to select the System Status Page.
124
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK 100
190-00645-07 Rev. A
™