Garmin G1000 Cockpit Reference Manual page 125

Message
TRAFFIC FAIL – Traffic device has
failed.
STRMSCP FAIL – Stormscope has
failed.
FAILED PATH – A data path has
failed.
MAG VAR – Large magnetic
variance. Verify all course angles.
SCHEDULER [#] – <message>.
SVT DISABLED – Out of available
terrain region.
SVT DISABLED – Terrain DB
resolution too low.
USER MAG VAR – User magnetic
variation is active.
CHECK CRS – Database course for
LOC1 / [LOC ID] is [CRS]°.
CHECK CRS – Database course for
LOC2 / [LOC ID] is [CRS]°.
[PFD1, PFD2, or MFD1] CARD
1 REM – Card 1 was removed.
Reinsert card.
[PFD1, PFD2, or MFD1] CARD
2 REM – Card 2 was removed.
Reinsert card.
190-00645-07 Rev. A
The system is no longer receiving data from
the traffic system. The traffic device should be
serviced.
Stormscope has failed. The G1000 system
should be serviced.
A data path connected to the GDU or the GIA
63/W has failed.
The GDU's internal model cannot determine
the exact magnetic variance for geographic
locations near the magnetic poles. Displayed
magnetic course angles may differ from the
actual magnetic heading by more than 2°.
Message criteria entered by the user.
Synthetic Vision is disabled because the aircraft
is not within the boundaries of the installed
terrain database.
Synthetic Vision is disabled because a terrain
database of sufficient resolution (9 arc-second
or better) is not currently installed.
User magnetic variation mode was selected
during previous operation and is still active
(checked at power-up.)
Selected course for LOC1 differs from published
localizer course by more than 10 degrees.
Selected course for LOC2 differs from published
localizer course by more than 10 degrees.
The SD card was removed from the top card
slot of the specified PFD or MFD. The SD card
needs to be reinserted.
The SD card was removed from the bottom card
slot of the specified PFD or MFD. The SD card
needs to be reinserted.
Garmin G1000 Cockpit Reference Guide for the Quest KODIAK
Annunciations & Alerts
Comments
100
™
109