Troubleshooting - Zanussi ZCI66050BA User Manual

Use the same oven lamp type.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
You cannot activate or operate
the hob.
You cannot activate or operate
the hob.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
Automatic Heat Up function
does not operate.
The sensor fields become hot.
There is no signal when you
touch the panel sensor fields.
comes on the hob display.
comes on the hob display.
4. Install the glass cover.
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
The zone is not hot because it
operated only for a short time.
The zone is hot.
The highest heat setting is set.
The cookware is too large or
you put it too near to the con-
trols.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or the
Lock function operates.
Remedy
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Put large cookware on the rear
zones if possible.
Activate the signals.
Refer to "Hob - Daily use"
chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Hob - Daily use"
chapter.
23