Boot Card Setup; Device For Remote Control - Panasonic PAN9026 Quick Start Manual



3.1 Boot Card Setup

The Wandboard actually consists of two separate parts: the Baseboard that contains all the
connectors and a system-on-module that contains the i.MX6 processor.
The system-on-module is located on the back of the Wandboard and may have a heat-spreader
covering the processor.
The Wandboard has two µSD card slots: one for the boot medium, which is located on the
system-on-module, and one for peripheral devices, which is located on the Baseboard.
Ideally the µSD card with the Ubuntu Linux image is already inserted in the µSD card slot on the
system-on-module so that the Wandboard will boot from it.
If not, please notice that the µSD card slot of the system-on-module can be found on the left
side when the Wandboard is turned around and the audio connectors are facing downwards:
If the µSD card needs to be changed, gently press the connector and the µSD card will spring
out.
Please remember the orientation of the contacts – the contacts must face upwards when the
µSD card is inserted.

3.2 Device for Remote Control

Certain functions of the PAN9026-IMX can be remote controlled via Wi-Fi, so a Wi-Fi capable
device for controlling is needed.
For the sake of simplicity it is assumed that an Android mobile phone is used for this purpose,
but other devices may be used as well.
Quick Start Guide Rev. 1.1
PAN9026 Wi-Fi/BT Module
3 Installation
Page 8