Installation; Boot Card Setup - Panasonic PAN9026 Developer's Manual



3 Installation

The PAN9026-IMX consists of the following components:

PAN9026-MSD – µSD card form factor

Wandboard Dual (WB-IMX6U-BW)

USB Power cable as power supply
The following additional components are not included, but are required for all use cases:
 µSD card with at least 2 GB capacity
 RS232 serial connection cable (interface the built-in UART port to a control PC)
 Some Wi-Fi capable device like a mobile phone or a tablet
Finally the following additional components are not included, but may be required depending on
the use case:
 Headphones with 3.5 mm jack (in order to listen to Bluetooth audio)

3.1 Boot Card Setup

The Wandboard actually consists of two separate parts:

The Baseboard that contains all the connectors and

A system-on-module that contains the i.MX6 processor.
The system-on-module is located on the back of the Wandboard and may have a heat-spreader
covering the processor.
The Wandboard has two µSD card slots:

One for the boot medium, which is located on the system-on-module, and

One for peripheral devices, which is located on the Baseboard.
Usually the µSD card with the Ubuntu Linux image is already inserted in the µSD card slot on
the system-on-module so that the Wandboard will boot from it.
Developer's Guide Rev. 1.0
PAN9026 Wi-Fi/BT Module
3 Installation
Page 8