Resetting Lock To Factory Default; Adding Lock To Z-Wave Plus Network - Yale Real Living YRD156 Installation And Programming Instructions

Resetting Lock to Factory Default

When lock is reset to factory defaults all
user codes (including the Master PIN
code*) are deleted and all programming
features are reset to original default
settings (see "Factory Default Settings").
1. Remove the battery cover.
2. Remove the batteries.
3. While pressing the reset button
(minimum of 3 seconds) reinstall
batteries. Release reset button.
4. Replace battery cover.
Upon reset, Master Code creation is the
only option available and must be
performed prior to any other
programming of the lock.
NOTE : After setting the Master Code,
press any key to complete handing of
the lock.

Adding Lock To Z-Wave Plus Network

Your network controller first needs to be in
inclusion or exclusion mode for the lock to
be added or removed from network.
Once you put the controller in the
inclusion or exclusion mode, the lock can
be added or removed in the Z-Wave Plus
Plus network by pressing the button
To add lock using the
1. Remove the battery cover.
2. Press button and hold until unit beeps
two (2) times.
3. Release button and network joining
automatically begins.
4. Replace battery cover.
To remove lock using the
1. Remove the battery cover.
2. Press button and hold until unit beeps
five (5) times.
3. Release button and network removal
automatically begins.
4. Replace battery cover.
.
button option:
button option:
P/N AYRD 156-INST FUL -
15
- Rev A