Resetting Lock To Factory Default - Yale T1L Installation And Programming Instructions

Resetting Lock to Factory Default

When lock is reset to factory defaults all user codes
(including the Master PIN code*) are deleted and all
programming features are reset to original default settings
(see "Factory Default Settings").
1. Remove the battery cover.
2. Remove the batteries.
3. While pressing the reset button (minimum of 3 seconds)
reinstall batteries. Release reset button.
4. Replace battery cover.
Upon reset, Master Code creation is the only option
available and must be performed prior to any other
programming of the lock.
NOTE: After setting the Master Code, press any key to
complete handing of the lock.
Enrolling Lock In
Your network controller first needs to be in enrollment
or exclusion mode for the lock to be enrolled or
removed from network.
Once you put the controller in the enrollment or
exclusion mode, the lock can be enrolled or removed
®
in the Z-Wave network two ways - through the
touchscreen using the #7 key (see Programming
Through Menu Mode) or by pressing the
To enroll lock using the
1. Remove the battery cover.
2. Press button and hold until unit beeps two (2)
times.
3. Release button and network joining automatically
begins.
4. Replace battery cover.
To remove lock using the
1. Remove the battery cover.
2. Press button and hold until unit beeps five (5)
times.
3. Release button and network removal automatically
begins.
4. Replace battery cover.
button.
button option:
button option:
P/N AYRD-120-INST-FUL Rev G
Network
® ®
15