AEG SYSTEM PRO Operating Instructions Manual page 9

GB Carrying and storag
DK Transport og opbevaring
SV Transport och förvaring
NO Transport og oppbevaring
FI Kuljetus ja säilytys
20
Maintenance and cleaning
GB
For maintenance or cleaning, switch off the appliance and unplug it from the mains. As required, wipe
the housing and the dustbag chamber with a damp cloth and then dry. Do not use any scourers or any
solvents. Occasionally vacuum the floor nozzle and the brush-heads with the crevice nozzle.
What to do, if...
... it is difficult to push the nozzle:
Reduce suction power (depending on the type of carpet).
This will not conspicuously reduce the cleaning efficiency.
... the motor thermal cut-out has tripped:
e. g. as the result of overloading the motor if the dustbag is full or if an accessory is blocked. Switch off
the appliance, unplug from the mains, and leave the motor to cool down. Check dustbag, suction tube
and suction hose; remove any blockage. The appliance can be switched on again after approximately
30 minutes.
... the fuse has blown:
The fuse can be blown if other electric appliances with a high power consumption are used at the same
time and on the same circuit as the vacuum cleaner.
If this is the case, set the suction power regulator to the lowest setting before switching on and only
select a higher suction level after switching on.
... the cable does not retract fully:
The cable is caught up on the cable drum.
Pull the cable out again a little and press button A again.
... the dust chamber lid will not close:
Check that the dustbag has been inserted.
If it has, check that the dustbag has clicked into position.
Protecting the environment
Appliance packaging:
We recommend keeping the packaging for the duration of the guarantee so
that the appliance can be transported safely.
Recycling the appliance at the end of its life:
The plastic components all carry a material identification marking so that, like the other materials, they
can be recycled at the end of the life of the
appliance.
21