Digital Sensor
(PL-T1000)
Auxiliary Analog Input
The T1000 has auxiliary analog input which can be used to connect
another thermistor. The T1000 can be configured to use this alternate
temperature reading for a variety of functions, including temperature
averaging or radiant floor slab temperature. The alternate thermistor
(10KΩ type 3) can be connected to the auxiliary input using the "AUX
IN" and "COM" pins. (See figure below)
Analog Input
Operation
The T1000 is controlled using the circular touch pad on the bottom half
of the thermostat. The touch pad uses capacitive sensing technology
to detect finger proximity. There are no moving parts to push or rotate.
The T1000 is controlled using simple scrolling, tapping or holding
motions, performed around the circle of the touch pad. The center of
the circle is unused.
Tap here to
go BACK
12
REV 1.0 / PL-QCK-WSENSOR/VC2000-EN
5
6
7
8
9
10
Scroll clockwise or
counterclockwise
to adjust or navigate
Tap here to
ENTER
Changing the Setpoint
Home Screen
Scroll or tap
(any direction)
View current zone
temperature
Tap anywhere
(or simply wait)
Home Screen
Schedule Override
The First, go to the Setpoint screen.
67.5
79.5
The moon icon
indicates
unoccupied mode
Scroll clockwise
to override
REV 1.0 / PL-QCK-WSENSOR/VC2000-EN
Setpoint Screen
Heat SP
Cool SP
Adjust your setpoint
by scrolling clockwise
return to
or counterckwise
The sun icon is
displayed when
overridden
67.5
79.5
OVERRIDE ACTIVE
(Occupied mode)
13