SOMFY Sonesse Ultra 50 RTS Instructions Manual
Hide thumbs
Also See for Sonesse Ultra 50 RTS:
- Instructions manual (76 pages) ,
- Quick programming manual (4 pages) ,
- Universal quick programming manual (2 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SOMFY Sonesse Ultra 50 RTS
Summary of Contents for SOMFY Sonesse Ultra 50 RTS
- Page 1 Sonesse Ultra 50 RTS Sonesse Ultra 50 RTS RH Instructions Notice...
-
Page 3: Table Of Contents
ORIGINAL GUIDE These instructions applies to all Sonesse Ultra 50 RTS and Sonesse Ultra 50 RTS RH drive irrespective of torque and speed variations. Contents 1. Prerequisite information 3. Use and maintenance 1.1 Fields of application 3.1. Up and Down buttons 1.2 liability... -
Page 4: Liability
Any After-Sales Service operation on the drive must be performed by a drive and home automation professional. If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser or go to the website www.somfy.com. -
Page 5: Wiring
Leave the drive power supply cable accessible: it must be possible to replace it easily. Switch off the power supply. Connect the drive according to the information in the table below: Neutral Live Earth 120V-60Hz White Black Green Copyright © 2014 Somfy SAS. All rights reserved. Images not contractually binding... -
Page 6: Commissioning
The lower end limit is memorised. The motorised product rises and stops in the raised position. 2.3.4. Validation of the setting To confirm the end limits, press the my button until the motorised product moves up and down. The end limits are programmed. Copyright © 2014 Somfy SAS. All rights reserved. Images not contractually binding... -
Page 7: Tips And Recommendations For Installation
If the motorisation is no longer in programming mode, repeat step 2.3.1 then perform step 2.3.4. 2.3.6. adding/deleting somfy control points and sensors Refer to the corresponding guide. 2.4. tIPs and reCommendatIons for InstallatIon 2.4.1. questions about the sonesse Ultra 50 rts? Observations Possible causes Solutions The wiring is incorrect. - Page 8 4) To confirm the new end limit, press the my button until the motorised product moves up and down. 2.4.3. replacing a lost or broken somfy control point Only switch off the power to the application to be reset.
-
Page 9: Use And Maintenance
3. Use and maIntenanCe PROG. This drive is maintenance-free For the safety of goods and people, Somfy motors are equipped with thermal protection that will trigger the motor stops in the event of overheating. Repeated achieving this protection can degrade engine performance. -
Page 10: Additional Settings
(my). 2) Press my again until the motorised product moves: the favourite position (my) is deleted. 3.5. tIPs and reCommendatIons for Use 3.5.1. questions about the sonesse Ultra 50 rts? Observations Possible causes Solutions... -
Page 11: Technical Data
Maximum number of sensors Somfy hereby declares that the drive covered by these instructions when marked for input voltage 230V 50Hz when used as intended according to these instructions, is in compliance with the essential requirements of the Machinery Directive 2006/42/EC and the R&TTE Directive 1999/5/EC. - Page 13 Somfy SAS 50 avenue du Nouveau Monde F-74300 CLUSES www.somfy.com...