Function Settings - TAS ProSpot Manual

18. Function settings

The display panel of the ProSpot allows several parameter settings to be altered,
which may prove useful on installation or later.
ATTENTION! Altering the tas factory settings may vary the functioning of the
projector, causing it to not respond to external DMX 512 signal. Please read and
familiarise yourself with the following information very carefully before altering any
selections.
1) Press the + or – buttons to display SPEC (for special).
+ --
menu enter
2) Press the enter button.
18.1 Turning off the display (
This function allows the display to be switched off should it be distracting.
From the SPEC function (point 2)
3) Press the + or – buttons to display dISP (for display).
+ --
menu enter
4) Press the enter button.
5) Press the + or – buttons to display On if you wish the display to stay on.
+ --
menu enter
6) Press the + or – buttons to display Off if you wish the display to be off.
+ --
menu enter
7) Press the enter button to confirm your selection. the display will turn off after 2
minutes.
Pressing any of the 4 menu display buttons will cause the display to switch on
again.
18.2 Adjusting display intensity (dint)
This function allows the display's intensity to be adjusted.
From the SPEC function (point 2)
3) Press the + or – buttons to display dint (for display intensity).
+ --
menu enter
4) Press the enter button to confirm your selection.
5) Press the + or – buttons to display the intensity level (from 20 to 100) required.
6) Press the enter button to confirm your selection of intensity.
18.3 Inhibiting lamp on/off via DMX (dLoF)
This function controls the lamp on/off switching via DMX.
From the SPEC function (point 2)
)
dISP