TAS ProSpot Manual page 18

LAMP
This function allows for the on/off control of the lamp via DMX512 signal, or for
the permanent on (disenabling DMX control of this function) of the lamp.
1) Press the + or – buttons to display LAMP (for lamp).
+ --
menu enter
2) Press the enter button to confirm your selection; the display will show off (for
lamp off).
+ --
menu enter
3) Press the + or – buttons to display on (for lamp on).
+ --
menu enter
4) Press the enter button to confirm your selection. The lamp will come on if you
selected on and will remain off if you selected off.
dEMo
This function allows two types of self-test procedures to be carried out without the
need for an external controller.
Mod 1 is used to test single functions at the choice of the operator of the unit.
Mod 2 is used to run an automated test sequence of all the functions of the
ProSpot.
1) Press the + or – buttons to display dEMo (for demonstration).
+ --
menu enter
2) Press the enter button
Mod1
1 Press the + or – buttons to display Mod1 if you wish to test single functions.
+ --
menu enter
2) Press the enter button
3) Press the + or – buttons to display Pan (dEmo Pan movement).
+ --
menu enter
4) Press the enter button.
5) The number of the display corresponds to the position of the projector. Press the
+ or – buttons and the number will change in the range from 0 to 255 displaying
the complete movement of the projector in the pan direction.
6) Press the + or – buttons to display tilt (dEMo tilt movement).
+ --
menu enter