TAS ProSpot Manual page 19

7) Press the enter button
8) The number of the display corresponds to the position of the projector. Press the
+ or – buttons and the number will change in the range from 0 to 255 displaying
the complete movement of the projector in the tilt direction.
9) Press the + or – buttons to display Foc (dEMo focus function).
+ --
menu enter
10) Press the enter button
12)The number of the display corresponds to the position of the focus lens. Press the
+ or – buttons and the number will change in the range from 0 to 255 displaying
the complete movement of the focus lens.
13) Press the + or – buttons to display Go (dEMo gobos).
+ --
menu enter
14) Press the enter button.
15) All the gobos or effects in the gobo wheel will be displayed in turn. Whilst this
is being undertaken, the display will show run.
4) To return to normal operation, press the menu button repeatedly.
Mod2
1) Press the + or – buttons to display Mod2 (this function tests all the features of
the ProSpot and allows all the features of the unit to be viewed).
+ --
menu enter
2) Press the enter button.
3) The display will show run and all the features of the fixture will be run.
rESE
This function causes a reset to occur in the case (however unlikely) that one or more
of the motors should lose its reference point.
1) Press the + or – buttons to display rESE (for reset).
+ --
menu enter
2) Press the enter button to confirm your selection; all the motors will perform a
reset.