Gobo Replacement - TAS ProSpot Manual

15. Gobo replacement

ProSpot allows gobos to be replace via a simple gobo retention spring system.
Replacement gobos should be manufactured from dichroic glass or metal.
The tas reseller network carries a wide range of replacement gobos.
replacing gobos on the rotating gobo wheel
Gobos may be replaced as required to produce special effects as required.
Gobo replacement should always be carried out with the power to the unit shut off, and
the top and bottom housing removed as described in section 16 "Maintenance".
1) Rotate the gobo wheel until you locate the gobo you wish to remove.
2) Remove the retaining spring and remove and then replace the gobo.
3) Replace the retaining spring, ensuring that it is seated correctly.