3-way/darts on-wall center channel loudspeaker (16 pages)
Summary of Contents for Induction Dynamics SolidDrive SD1
Page 1
INSTALLATION & USE GUIDE for SolidDrive SD1 into walls and ceilings ® I I N N D D U U C C T T I I O O N N D D Y Y N N A A M M I I C C S S ®...
Page 2
For retrofitting the SolidDrive SD1 into existing drywall installations, it will be necessary to remove a portion of the existing drywall before installation and to replace the drywall after the SolidDrive SD1 is installed. Please refer to the instructions marked with EXISTING DRYWALL for the steps necessary for the type of installation.
Page 3
Eurostyle connector attached sets up (approximately 10 minutes). This allows to the end of the SolidDrive SD1 audio cable. The polarity of adjustment of the panel before the final location is the wiring is clearly indicated (Figure 4).
SolidDrive SD1 In-Wall and SolidDrive SD1 Specifications In-Ceiling Mounting Bracket Specifications ® Type Full Range Transducer Impedance 8 Ohm Type Patent-pending balanced cantilever spring bracket Frequency Response (Hz) 70 Hz to 15 kHz Construction Heavy duty, galvanized steel Recommended Amplifier Power 10 –...
Need help?
Do you have a question about the SolidDrive SD1 and is the answer not in the manual?
Questions and answers