ABB REF615 ANSI 5.0 FP1 Product Manual page 13

13
—
Table 2. Supported functions, continued
() = optional
1) One of the following can be ordered as an option; Admittance based E/F, Wattmetric based E/F or Harmonics based E/F. The option is an addition to the existing E/F of the
original configuration. The optional E/F has also a predefined configuration in the relay. The optional E/F can be set on or off.
2) Multi-purpose protection is used for, for example, RTD/mA based protection, or Analogue Goose
3) Light only
4) Io selectable by parameter, Io measured as default
5) Io selectable by parameter, Io calculated as default
6) Io calculated is always used
7) IoB calculated is always used
8) IoB calculated and 3IB are always used
9) Uo selectable by parameter, Uo measured as default
10) Uo calculated and negative sequence voltage selectable by parameter, Uo calculated as default
11) Uo calculated is always used
12) Uo measured is always used
13) IoB measured is always used
14) IoB measured and 3IB are always used
15) Io measured is always used
16) IoB selectable by parameter, IoB measured as default
17) Power quality option includes Current total demand distortion, Voltage total harmonic distortion and Voltage variation.
18) Available in IED and SMT but not connected to anything in logic.
19) Must be added with ACT to be available in SMT and in IED.
20) Uob measured is always used for unbalance protection with unearthed single Y connected capacitor bank.
21) The Iunb measurements values will be taken from this block and put in Measurent view.
22) Master Trip included and connected to corresponding HSO in the configuration only when BIO0007 module is used. If additionally the ARC option is selected, then ARCSARC
is connected in the configuration to the corresponding Master Trip input.
23) Only available with COM0031-0037
24) Power quality option includes only Current total demand distortion
25) Unbalance voltage measurement for capacitor bank for REV615
26) Only available with IEC 61850-9-2
LV) The function block is to be used on the low voltage side in the application
HV) The function block is to be used on the high voltage side in the application
NT) The function block is to be used on the neutral side in the application
TR) The function block is to be used on the terminal side in the application
BS) The function block is to be used on the bus side in the application
EX) This function to be excluded from the Integration Test Data generation