Makita VC1310L Instruction Manual page 9

1. Storing the power supply cord
NOTE:
Do not use the cleaner or a connected electric
•
power tool with a power supply cord wound on
the base hook. Using the cleaner or the connected
electric power tool with power supply cord may
cause damage the power supply cord.
Fig.6
2. Storing the front cuffs
Front cuffs 22, 24 and 38 can be stored (up to two at a
time.)
Fig.7
3. Storing the hose
Fig.8
4. Resting a reasonable size of electric power
tool for the base hook, such as circular saw.
Fig.9
Locking or unlocking the caster
For Models VC1310L and VC2510L
Fig.10
For Model VC3210L
Fig.11
To lock the caster with a stopper, lower the stopper lever
and the caster no longer will rotate. To release the caster
from the locked position, raise the stopper lever.
Locking the caster is convenient when storing the cleaner,
stopping the work on the way and keeping the cleaner
still.
To operate the stopper, move it by hand.
NOTE:
When moving the cleaner, make sure that the
•
caster is unlocked. Moving the cleaner with the
caster in the locked position may cause damage to
the caster.
ASSEMBLY
CAUTION:
Always be sure that the cleaner is switched off and
•
unplugged before carrying out any work on the
cleaner.
Installing the water filter
6
1. Tank cover
2. Powder filter
3. Damper
4. Prefilter
5. Tank
6. Mounting position marking
011637
To pick up water or wet dust, remove prefilter and
damper and then use water filter.
3
1. Water filter
2. Tank
3. Mounting position marking
011630
When installing the water filter on the tank, set it tight at
the opening of the tank so that the hook of the water filter
engages the tank opening firmly and there is no space
between the water filter and the tank.
Also, install the water filter so that the mounting position
marking can be aligned.
9
1
2
3
4
5
1
2