ADC Diagnostix Otoscope PMV Series Instruction Manual page 7

Plug-in Handle
Prior to initial use of the plug-in handle,
it should be charged for up to 24 hours
in the mains socket.
To charge Diagnostix
rechargeable handles, desk charger base
(# 5500) is required. Follow "Instructions
for Use" supplied with desk charger.
To change plug-in handle, remove top
portion by unscrewing counter-
clockwise to reveal 2 prong plug in lower portion. Plug into electrical outlet.
CAUTION:
• If you do not plan to use the device for a long time or if you travel with it,
remove the rechargeable batteries from the handle.
• New batteries should be inserted once the light intensity of the
instrument becomes weaker, even on a full charge.
• To obtain the best possible light output we recommend always fitting
high quality batteries (as described in 4.3).
• If you suspect that liquid or moisture could have entered the handle, it
must not be charged under any circumstances. This could lead to a
life-threatening electric shock, especially in the case of plug-in handles.
• To extend the service life of the battery, the battery should only be
charged once the light intensity of the instrument has become weaker.
• Plug-in handle should be charged overnight (12 hours) to ensure
uninterrupted power supply.
NOTE for #5460: 3.5 V for charging in a 120 or 230 V wall socket.
When using the new 5460BAT, care must be taken to ensure that no
insulation is affixed to the spring of the battery-handle cap. If the old
5460BAT is used, an insulation must be affixed to the spring to avoid
short circuit.
New
standard
TM
Rechargable
Plug-in Handle
Old
7
Recharger Base
sold separately