Installation - Kenwood TK-5310 K4 Service Manual

TK-5310
Voice Guide & Storage Unit (VGS-1:Option)
■ Installing the VGS-1 unit in the transceiver
1. Remove the 4 screws from the cover.
2. Remove the cover by inserting the tip of a pair of tweezers
into the screw hole of the cover and prying it open.
3. Remove the OPTION PCB from the connector (CN609) of
the TX-RX PCB.
OPTION PCB
CN609
4. Attach two cushions to the VGS-1 as shown in the figure 3.
Note:
Be sure not to cover the VGS-1 connector (CN1) with the
cushion.
10

INSTALLATION

Fig. 1
Fig. 2
5. Insert the VGS-1 connector (CN1) into the connector
(CN609) of the TX-RX PCB.
VGS-1
CN1
CN609
Fig. 3
6. Reinstall the cover using the 4 screws removed in step 1.
Note:
You must setup using the KPG-95D.
Cushion
(G13-1995-04)
20X30X1.0mm
VGS-1
Cushion
(G13-1974-04)
21X21X1.0mm