Kenwood TK-5310 K4 Service Manual page 7

Key operation
Item
Zone-Channel RX Frequency
Key
[A]
Zone/Channel
[B]
switching
Zone/Channel
[C]
down
Zone/Channel
[D]
up
Data
[Side3] Unused
writing
Keypad
[0]~[9]
Unused Go to the direct enter mode
(K3 and K6
models only)
Item
RX NAC
Key
[A]
Delete the least digit from the current number
[B]
(Press and hold to delete all numbers.)
[C]
[D] Determine the least digit
[Side2] Increment a number in the specified digit
[Side3] Decrement a number in the specified digit
Keypad Add a digit to the current number
(K3 and K6 How to enter the "A" ~ "F" is follows.
models only) A : Press [2] with PTT
D : Press [0] with PTT
• Direct enter mode
Item
RX Frequency
Key
[A]
[B]
[C]
[D]
[Side3] ON/OFF switching at TX Frequency
Keypad
[0] ~ [9]
Keypad
[*]
Keypad
[#]
REALIGNMENT
TX Frequency Channel Type
5kHz/6.25kHz/1MHz
step switching
ANALOG/P25/MIXED
1 step down
switching(Back)
ANALOG/P25/MIXED
1 step up
switching(Forward) switching(Forward) switching(Forward)
ON/OFF
switching
TX NAC
Go to the next item
Unused
B : Press [5] with PTT C : Press [8] with PTT
E : Press [#] with PTT F : Press [*] with PTT
TX Frequency
Return to non-direct enter mode
Unused
Unused
Delete the least digit from the current number
(Press and hold to delete all numbers.)
Add a digit to the current number
Return to non-direct enter mode
Delete the least digit from the current number
(Press and hold to delete all numbers.)
TX Mode Channel Spacing
Go to the next item
Unused
ANALOG/P25 Channel spacing
switching(Back) switching(Back)
ANALOG/P25 Channel spacing
Unused
Unused
TG List No.
Unused
TG List
number down
TG List
number up
Unused
Unused
Unused
RX Signaling TX Signaling
Change the type of signaling and
return to non-direct enter mode
Unused
TK-5310
RX Signaling TX Signaling
QT/DQT(N)/DQT(I)/OFF
switching
Signaling down
Signaling up
1 step/Standard
switching
Go to the direct enter mode
(After selecting signaling type)
7