Kenwood TK-5310 K4 Service Manual page 6

TK-5310
8. Self Programming Mode
(K2, K3, K5 and K6 models only)
Write mode for frequency data and signaling etc. To be
used ONLY by the authorized service person maintaining the
user's equipment. After programming, reset the FPU to the
"Self- Programming" disabled mode. Transceivers CANNOT
be delivered to the end-user in the self-programming mode.
The following setup items in the channels programmed by
the FPU can be changed using the self-programming mode.
The addition of new channel and the deletion of channel that
has already been programmed by the FPU cannot be
performed using the self-programming mode.
• RX frequency
• TX frequency
• Channel type
• TX mode (When the channel type is selected "MIXED".)
• Channel spacing
• RX signaling
• TX signaling
• RX NAC
• TX NAC
• Talkgroup list number
Note:
The personality will be also changed when the above-
mentioned items is changed. (Refer to the FPU for the
personality details.)
Key guide on the "INPUT PASSWORD" display.
• CNF([A] key): The password confirmation
• DEL([B] key): Delete the least digit from the current pass-
word number (Press and hold to delete all
password numbers)
• SET([D] key): Determine the least digit of the password
number
The setup items for self programming mode are as follows.
No. Setup item
1 Select
Zone/Channel
2 RX frequency
3 TX frequency
4 Channel type
5 TX mode
6 Channel spacing
7 RX Signaling
8 TX Signaling
9 RX NAC
10 TX NAC
11 Talkgroup list number
6
REALIGNMENT
Display
ZONE [**] -CH *** Zone : 1~50
ZONE ** -CH [***] CH : 1~250
RX Freq Receive frequency
TX Freq Transmit frequency
CH Type ANALOG/P25/MIXED
TX Mode ANALOG/P25
CH Space 25.0kHz/12.5kHz (When the Channel type is selected "ANALOG" or "MIXED".)
P25 12.5kHz/12.5kHz (When the Channel type is selected "P25".)
RX Sig Receive QT/DQT
TX Sig Transmit QT/DQT
RX NAC *** 000~FFF (Hexadecimal)
TX NAC *** 000~FFF (Hexadecimal)
TG List No. *** 1~250
8-1. Enter to the self programming mode
Press and hold the [Side2] and [PTT] keys while turning
the transceiver power ON and then release the [PTT] key
first. Ignoring whether the Read authorization password is
set or not, "INPUT PASSWORD" appears.
If the Read authorization password is not set to the trans-
ceiver, "SELF PROG MODE" is displayed on the LCD when the
[A] key is pressed while "INPUT PASSWORD" is displayed.
If the password is set to the transceiver, "SELF PROG
MODE" is displayed on the LCD when you enter the correct
password while "INPUT PASSWORD" is displayed.
For the password input method, see "7. Clone Mode"
step 3 described on page 5.
Note :
This mode (self programming mode) cannot be set when
it has been disabled with the FPU.
8-2. Data Writing
If the [Side3] key is pressed while Zone/Channel mode is
displayed, new data is written into memory. "Writing" is dis-
played while the transceiver is writing data.
Remarks
Note : "F7F" cannot be set.
Note : "F7E" and "F7F" cannot be set.