Table of Contents
Advertisement
Introduction to the ProCurve 700wl Series
•
Set up Identity Profiles to put users in groups that share the same access policies
•
Set up Connection Profiles that allow you to specify different Access Policies for users based on
location, time of day, VLAN tags, and Authentication Policies
•
Set up redundant Access Control Servers to provide failover
Additionally, the Administrative Console provides functions for monitoring the status of the system
components, as well as monitoring clients logged onto the system and their sessions.
Order of Network Installation
The order of installation depends on the complement of equipment you wish to install. There are two
basic configurations, and for each, there is an order of network installation as follows:
•
Access Control Server 745wl with at least one XL Access Controller Module
•
Two redundant Access Control Server 745wls with at least one XL Access Controller Module
Access Control Server with One or More Access Controller Modules
If you are installing one Access Control Server 745wl and one or more XL Access Controller Modules,
perform installation in the following order:
Step 1.
Install the Access Control Server, following the steps in Chapter 2, "Hardware Installation" in this
manual.
Step 2.
Perform the network setup for the Access Control Server, following the steps in "Access Control
Server Setup" on page
Step 3.
Install the Access Controller Modules following the steps in the ProCurve Series 5300xl Switches
Installation and Getting Started Guide.
Step 4.
Once the Access Controller Modules are recognized by the Access Control Server and appear in
the Access Control Server Administrative Console, perform any additional setup required,
following the steps in"Completing the Installation" on page 3-15.
Redundant Access Control Servers with One or More Access Controller
Modules
Step 1.
Install each Access Control Server, following the steps in Chapter 2, "Hardware Installation" in
this manual.
Note: It is strongly recommended that an Access Control Server 745wl be used as the
secondary Access Control Server. If you use an Access Control Server 740wl as the redundant
Access Control Server, transferring the primary 745wl workload to a secondary 740wl may
result in the working integrity being compromised due to 740wl limitations.
Step 2.
Perform the network setup for each Access Control Server, following the steps in"Access Control
Server Setup" on page
1-2
3-2.
3-2.
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
Advertisement
Table of Contents
