System Memory/Storage; Chassis; Power Supply; Fans - HP ProCurve 745wl Installation And Getting Started Manual

Hide thumbs Also See for ProCurve 745wl:
Table of Contents

Advertisement

Hardware Installation
Figure 2-2 shows a front panel view of the Access Control Server 745wl.
Figure 2-2. Front panel view—Access Control Server 745wl

System Memory/Storage

The Access Control Server 745wl is equipped with a hard disk.

Chassis

The chassis is 17.00" (43.2 cm) wide, 22.00" (55.9 cm) deep, and 3.5" (8.9 cm) high, which is 2 rack units
(RU) high. It weighs approximately 35 lbs (15.9 kg). It can be rack-mounted using the front brackets
provided.

Power Supply

TheAccess Control Server 745wl contains an auto voltage sensing power supply. Input is 100-220 volts,
2.5A, 50/60 Hz, with a measured 350 watts output.

Fans

Note:
For environmental specifications, see
"Site Power Requirements and Heat Dissipation" on
page
2-5.
The system fan assembly provides cooling air for the internal chassis components. The fans exhaust warm
air from the back and draw in cool air at the front. The Access Control Server 745wl monitors its internal
fan speeds, internal chassis temperature, and power supply voltages. The status of these values are
reported by system software.

I/O Ports

Table 2-1 summarizes the functional I/O ports on the Access Control Server 745wl.
2-2
ProCurve Secure Access 700wl Series Installation and Getting Started Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve secure access 700wl seriesProcurve xl

Table of Contents