Table of Contents
Advertisement
Step 14.
Deselect the Microsoft CHAP (MS-CHAP) protocol option (this protocol is selected by default).
Leave Microsoft CHAP Version 2 selected. Only MS-CHAP v2 is set for use with the
Authenticated Access Policy.
Step 15.
In the Data Encryption drop-down list, select
declines)
. This sets the length of the encryption key to 128 bits.
Step 16.
OK
Click
to go back to the connection's properties dialog box.
Step 17.
OK
Click
to go back to the Properties dialog box.
Step 18.
OK
Click
to close the Connect dialog box.
User Authentication Via PPTP Connection
Before starting the VPN connection, make sure your system has established a network connection with
the Access Control Server. You can use the
command to obtain an IP address from the Access Control Server.
ipconfig /renew
Step 1.
Open the PPTP connection you created in "PPTP Client Configuration" on page 4-8 by using the
shortcut on your desktop or open the connection from the Network Connections dialog box in
the Control Panel.
The Connect dialog box appears.
Step 2.
Type demo and password, or the user name and password you created in the built-in database, in
User name
the
You may choose to save this user name and password for future use by checking the
Password
check box before clicking
After the connection is successful, the connection icon appears in the system tray on the lower-right
corner of your screen as shown in Figure 4-10.
Figure 4-10. Connection Icon
External Authentication Service Configuration
If you use an external RADIUS authentication service and your user account already exists in the
RADIUS server's database, you can configure the 700wl Series system to authenticate using the RADIUS
server rather than the built-in database.
Once you have successfully completed this configuration, you should be able to log on to the network
through the 700wl Series system using any legitimate user name and password recognized by your
RADIUS server.
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
ipconfig
Password
and
text boxes, and click
Connect
Maximum strength encryption (disconnect if server
command to verify the IP settings or use the
Connect
to connect.
.
Basic Configuration
Save
4-11
Advertisement
Table of Contents
