Changing The Enforcement Server Network Settings; Changing The Enforcement Server Date And Time - HP 800 User Manual

CAUTION:
NOTE:
NOTE:

Changing the Enforcement Server Network Settings

Back up your system immediately after changing the MS or ES IP address. If
you do not back up with the new IP address, and later restore your system, it
will restore the previous IP address which can show an ES error condition
and cause authentication problems. See "Maintenance" on page 3-91 for
instructions on backing up and restoring your system.
To change the Enforcement server network settings:
NAC 800 Home window>>System configuration>>Enforcement clusters &
servers>>Select an ES>>Configuration
Modify any of the following Network settings you want to change:
Enter a new Enforcement server in the Host name text field. For
■
example, garp.mycompany.com
Enter a new Enforcement server address in the IP address text field.
■
For example, 192.168.153.35
Enter a new netmask in the Network mask text field. For example,
■
255.255.255.0
Enter a new gateway in the Gateway IP address text field. For example
■
192.168.153.2
■ Enter one or more DNS resolver IP addresses, separated by commas,
semicolons, or spaces in the DNS IP addresses text box. For example:
10.0.16.100,10.0.1.1
The NAC 800 Enforcement server's host name must be a fully qualified domain
name (FQDN). For example, the FQDN should include the host and the
domain name—including the top-level domain.
For example, waldo.mycompany.com. Select names that are short, easy to
remember, have no spaces or underscores, and the first and last character
cannot be a dash (-).
You cannot change the ES IP address for a single-server installation. You can
change the MS IP address for a single-server installation.

Changing the Enforcement Server Date and Time

To change the Enforcement server date and time:
System Configuration
Enforcement Servers
3-17