Table of Contents
Advertisement
Figure 3-8. Local Networks Page
Step 6.
If appropriate, enter a fully-qualified hostname for this Access Control Server.
Step 7.
Enter the name of the domain in which this Access Control Server resides.
Step 8.
To use DHCP to obtain an IP address for this unit, select
down list.
Configure
When
Gateway. You can change the DNS and WINS server IP addresses, if necessary.
If your DHCP server is configured appropriately, the IP address, subnet mask (netmask),
gateway, and primary and secondary DNS addresses will already be filled in.
Step 9.
To set a static IP address, select
Address and other values, as appropriate, in the fields on this page.
Step 10.
Save
Click
.
ProCurve Secure Access 700wl Series Installation and Getting Started Guide
Using DHCP
is set to
, you cannot change the IP Address, Subnet Mask, or
Manually
Using DHCP
Configure
from the
drop-down list, then type the IP
Network Setup
Configure
from the
drop-
3-11
Advertisement
Table of Contents
