Table of Contents
Advertisement
H
ARDWARE
This chapter describes the hardware installation of the ProCurve Access Control Server 745wl. (The XL
Access Controller Module is installed in the 5300xl switches, and, therefore, its installation is described in
the ProCurve Series 5300xl Switches Installation and Getting Started Guide.) You must be sure that the site
requirements are met and carefully follow the procedures described to physically install the equipment.
This chapter consists of the following sections:
Hardware Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Site Planning Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4
Installing a 700wl Series System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-6
Hardware Description
This section describes the hardware features of the Access Control Server 745wl, which is designed for
high-performance, high-density wiring-closet applications. Figure 2-1 shows an Access Control Server
745wl.
Figure 2-1. Access Control Server 745wl
The Access Control Server 745wl consists of a chassis, power supply, fans, I/O ports, indicators, and
switches. This unit has two RJ-45 connectors—one for the network uplink, used to connect the unit to the
network, and one that is used for the redundant Access Control Server.
I
NSTALLATION
2
2-1
Advertisement
Table of Contents
