FUTABA SkyLeaf BP Instruction Manual page 8

3 Example of setting S.BUS servo with T18MZ / T12K
This aircraft is equipped with four aileron servos, so it is convenient to use S.BUS. In advance,
decide the servo to be used and set the S.BUS Servo setting for each channel shown below.
This page is unnecessary when S.BUS is not used.
CH1
Left
Aileron
CH7
Left
Aileron
CH2
Left
Elevator
CH3
Throttle
CH1
Left
Aileron
CH5
Left
Aileron
CH2
Left
Elevator
CH11
Throttle
！ For EP with T12K: If model type is 4 AIL + 2 FLP, throttle will be CH11. There is no CH11 output
port in the receiver (default setting), so you need to set CH MODE to MODE D and change the
receiver's CH3 port to CH11 output.
8
Put the name on the label and paste it on each servo.
Channel setting example when S.BUS is used: T18MZ
CH6
Right
Aileron
CH8
Right
Aileron
CH5
Right
Elevator
EP: Motor controller
CH4
connected to CH3 port.
Rudder
Channel setting example when S.BUS is used: T12K
CH4
Right
Aileron
CH6
Right
Aileron
CH12
Right
Elevator
EP: Motor controller
CH3
connected to CH3 port.
Rudder
Write the channel to
the servo with S.BUS
Servo.
T18MZ setting
◆Model Type
AIRPLANE
Wing Type → 4AIL+2FLP
Tail Type → AILVATOR
T12K setting
◆Model Type
AIRPLANE
WING → 4AIL+2FLP
TAIL → AILVATOR
In case of EP
R3008SB
◆CH MODE
Change to MODE Ｄ