FUTABA SkyLeaf BP Instruction Manual page 14

4
● Move the Rudder after drying. Check that the
aileron is securely attached.
6
● Linkage as shown. Use your radio to center
your servos. Attach a servo horn to each
servo so that the horn is vertical position.
7 Attach the Horizontal stabilizer
1
1
● Insert the Horizontal stabilizer tube
into fuselage.
14
● Insert the Horizontal
stabilizer tube straight
into the mounting hole.
5
● The hole on the wood under the film. Cut the
film of that part. (You can see through.)
! Servo hole cuts only on the right side.
Servo hole on the left side is not cut.
● Drill a hole in the wood screw in the servo mount.
Fix the servo with 4 wood screws.
2
1
● Insert the left and right Horizontal stabilizer into
the Horizontal stabilizer tube.
● Insert the Horizontal
stabilizer straight into the
Horizontal stabilizer tube.
● The side with Servo
is bottom.
3
● Fix the Horizontal stabilizer
with M3 × 16 Hexagon bolt
and M3 Washer.
● Elevator servo wire
is put in the fuselage.