FUTABA SkyLeaf BP Instruction Manual page 19

This page is an explanation of when to make it into an engine.
10 1
● Link servo with engine throttle. Make it work
smoothly.
● Drill a hole where
T h r o t t l e R o d
operates smoothly.
● A t t a c h i n g t h e
crank of Throttle
R o d i s d o n e b y
r e m o v i n g t h e
throttle arm from
the engine.
If the Rod is in contact with the metal part of the
engine, noise may occur due to vibration and
there is a danger of malfunction.
12
● Piping of fuel is done.
Fuel stopper / Filler neck
When using interior silencer
● Cut this film and wood.
● Apply epoxy glue or
clear paint to the cut of
the wood after cutting.
Do not let fuel infiltrate.
11
Put out outside
Pressure pipe
Nipple
To carburetor
Futaba and O.S. do not sell interior silencer.
● Screw the installation band of
(It is unnecessary in case of EP.)
● Adjust the throttle stroke. Do not overload
the throttle servo.
Set screw
Throttle adjuster
Washer
Servo horn
Washer
M2 Nylon Nut
Air tube
Silicon tube
Fuel tank
the silencer to the wood part
inside the fuselage.
Sky Leaf Tip
● Cut the excess rod after
adjusting the length.
Weight
19