System; To Configure System Settings - Xerox Wireless Print Solutions Adapter User Manual

5. For Remote Port, enter the port number for the remote host that supports logging services. The default
port number is 514.
6. For Severity Log Level, click the arrow to select the minimum level message type that you want the
system to log.
7. Click Submit.

System

Use the System page to reboot the Wireless Print Solutions Adapter or restore it to factory settings as
needed. You can reboot the device, restore factory defaults, upload new firmware and update its short and
long names.

To Configure System Settings

1. In the Web Manager, click the Administration tab.
2. Click System.
3. Select desired action:
– To reboot the Wireless Print Solutions Adapter, click Reboot.
Notes:
• When you reboot the Wireless Print Solutions Adapter, allow one minute for the process to
complete.
• After the reboot process completes, wait an additional 20 seconds before making any
connections to the adapter.
– To locate the device, click Locate Device. The Wireless Print Solutions Adapter will display a fast
green LED light that blinks for two minutes. For details, see
– To restore factory settings, click Factory Defaults, then to continue, click OK. The Wireless Print
Solutions Adapter reboots automatically.
Notes:
• If you restore the device to original factory settings, all configured settings are reset to the
default.
• After the reboot process completes, wait 20 seconds before you connect to the Wireless Print
Solutions Adapter.
– To update the firmware for your Wireless Print Solutions Adapter, see
page 44.
– To enable or disable Near Field Communication (NFC), for State, select an option, then click
Submit.
– To change the language for the Wireless Print Solutions Adapter, for Language, select an option,
then click Submit.
Status LED on page 15.
Installing New Firmware
®
Xerox Wireless Print Solutions Adapter
Administration Page
on
41
User Guide