Wired (eth0) Network Link Settings
To Configure Wired Network Link Settings
To view Wired Network (eth0) Interface status, on the Network page, select Wired Network > Link.
•
To modify Wired Network (eth0) Interface settings, on the Network page, select Wired
•
Network > Link > Configuration.
Physical link parameters can be configured for an Ethernet (eth0) Network Interface.
•
When speed is Auto, duplex must be Auto or Half.
•
When speed is not Auto, duplex must be Half or Full.
•
Fixed-speed Full duplex produces errors when connected to Auto, due to duplex mismatch.
Wireless (wlan0) Network Interface Settings
This page is used to configure and view the status of the wlan0 interface on the device. To see the effect of
these items after a reboot, view the Status page.
To Configure Wireless Network Interface Settings
•
To view the Wireless Network (wlan0) Interface status, on the Network page, then select
Wireless Network > Interface.
•
To modify Wireless Network (wlan0) Interface settings, on the Network page, select
Wireless Network > Interface > Configuration.
Wireless (wlan0) Network Link Settings
You can select and name up to four WLAN Profiles for automatic connection to wireless networks.
To Configure Wireless Network Link Settings
•
To view Wireless Network (wlan0) Interface status, on the Network page, select
Wireless Network > Link.
•
To modify Wireless Network (wlan0) Interface settings, on the Network page, select
Wireless Network > Link > Configuration.
WLAN Scan/Quick Connect
To view the WLAN Link Scan and Status information, on the Network page, select WLAN Scan/Quick
Connect.
®
Xerox
Wireless Print Solutions Adapter
Network Page
23
User Guide