Entering Selectable Features Mode; Installation; General Guidelines - Beltronics Vector 940 Operating Instructions Manual

Entering Selectable Features Mode

1. With the unit OFF, press and hold the PWR and CTY
buttons simultaneously. The word "
appear in the display, followed by the status of the first
Selectable Feature.
2. Press the AUD button to make your selection.
3. Press the CTY button to move to the next Selectable
Feature. To move backward in the list, press the DRK
button.
4. Press the PWR button to exit Selectable Features mode.
To confirm your unit is ready for operation, and what
mode of travel your unit is operating, the display will
read: "
A A u u t t o o S S c c a a n n

Installation

General Guidelines

k
Do not mount your unit directly behind windshield
wipers or mirrored sunscreens which block Radar and
Laser signals and substantially reduce warning range.
Unlike "after market" mirrored sun-screens, regular
tinted glass does not affect Radar reception. Radar
signals are also reflected by "heated windshields"
known as Instaclear
option on some vehicles. This type of windshield makes
any dash, visor or windshield mounted detector
ineffective. (If in doubt, check with an appropriate
dealership to see if this applies to your vehicle.)
To achieve optimum performance, regardless of which
mounting position you choose, follow the basic steps
on the following page.
14
Instaclear is a registered trademark of the Ford Motor Company.
ElectriClear is a registered Trademark of Libbey, Owens, Ford, and Delco-Remy.
", " ", "
H H i i g g h h w w a a y y C C i i t t y y X X
® and ElectriClear
" will
F F E E A A T T U U R R E E S S
" or .
C C i i t t y y A A L L L L
® available as an