Set And Forget Memory; Reset To Factory Settings; Drk (Bright/Dim/Dark) Button - Beltronics Vector 940 Operating Instructions Manual

To exit Tutorial Mode, press the PWR button and
your unit will be on and ready to receive signals.
k

Set and Forget Memory

Any time your unit is turned off or unplugged from the
cigarette lighter socket, all feature settings you have
selected are retained in the unit's memory. Set and
Forget Memory eliminates the need to reset your
preferred feature settings each time your unit is
turned off and then back on.
k

Reset to Factory Settings

You can reset your unit to factory settings for Start-Up
mode, volume, DRK, AUD, CTY and General Selectable
Features. To reset, press and hold the CTY button until
the display shows
your unit will cycle through the
Mode.
k

DRK (Bright/Dim/Dark) Button

The DRK button allows selection of a bright, fully
adjustable dim or dark mode. Your unit is factory
preset to full bright display. To engage dim mode,
press and hold the DRK button. The display will
cycle through various levels of dim illumination.
Release the button at your chosen level. To engage
dark mode, press the DRK button a second time. A
single "beep" coupled with the brief illumination of
" "
on the display confirms your selection.
D D A A R R K K
You'll notice an
"
mode),
dim to confirm your unit is receiving power. To
return to a full bright setting, press the DRK button
a third time; two "beeps" confirm this selection. Use of
the DRK button does not affect audio alerts.
Important—if you press the the DRK button and do not
receive audible confirmation, the audio level has been set
8
too low.
R R E E S S E E T T
" " .
" "
(AutoScan
A A s s
"
(City mode) or
C C x x
Two "beeps" will sound and
Start-Up
N N O O R R M M A A L L
" "
™ ), (Highway
H H
" "
(City ALL) remains
C C A A